073: HS-100-LV (Shipment 15th of August 2026) This design lets you connect

This design lets you connect the main batteries to heat up the Cube and get GPS lock without powering up all the rest of the equipment

1x PL-4-6S BEC 3x

Specifications:

This Sensor board needs a power supply

The main purpose of this hub is to replace existing protection circuits (like an ideal diode) and to monitor

073: HS-100-LV (Shipment 15th of August 2026) This design lets you connect100A Current measurement sensor board, based on Allegro Hall Sensor ACS 100U. The voltage reading of the LiPo is optimized for up to 6S LiPo packs. This Sensor board needs a power supply. So please select the matching BEC according to your preference from the BEC section. The BEC will also power the flight controller as well as the attached equipment like GPS, telemetry etc. Connected to the sensor are 2x10cm AWG12 wire (red) as a standard. The board